What amperage is the fuse that is used on the P1020-K in the battery box?

The liftgate battery light on the direct nose box is blinking green, what does the indicate?

Inside the battery box, What position should the 1-OFF-2 selector switch be in for the Purkey’s liftgate charging system?

If the Direct box has no lights on it, which of the following is not a possible reason?

What is the name of the charging system for the Pepsi’s spec?

The orange wire on the P1020-K plate routes to the Direct controller, What is the orange wires purpose?

The Status is mounted where?

The 200 amp circuit breaker is wired between the liftgate batteries and the master disconnect switch

It is ok to replace the 200 amp circuit breaker with a 150 amp circuit breaker

How often do you grease the platform pivots?

When checking the oil level to ensure it is at the proper level, the platform should be in what position?

What is the BMR-55 raise speed time frame?

The recommended clearance between the columns and the runner pad should be?

The tip of the platform does not require adjustment if it is _____ or less of the runners touching the ground.

How much grease should be in the columns of a BMR gate when performing maintenance?

Maxon uses positive lock connectors on all spade terminals that have a mechanical detent that needs to be pressed to remove the wire?

It is only required to verify the operation of the liftgate with the Master switch on position 1

When order new Maxon liftgate decals you will need to provide the ____________

Maxon uses open harnesses to allow for quick and easy repairs